Page 1 of 1

Error: When skipping pages, pages print 2x too wide

Posted: Wed Jan 16, 2013 10:37 am
by paulus
First of all, thanks for the fantastic Bullzip printer software.

I recently noticed an error while using Bullzip. When I printed a documented, I only wanted the odd pages to print, so I entered the following sequence in the selected pages field:
1,3,5,7,9.
In the preview, the pages where shown completely correct. However, when I printed the pages, all pages were scaled twice as wide, and half of the page did not show in the output.
Scaling was set to 'None''. This must be an error in calculation of the scaling factor by the software itself.